SAFETY SHOE - USER INSTRUCTIONS

Product:

Everlast Safety Shoe - DWEMWE137 – 7UK/14UK

Standards applied:

AS 2210:3:2019-ISO20345.:2011

Marking: Everlast Steel Toe Cap Shoe

Intended Use: This safety footwear is designed to provide protection against the hazards of which it has been tested and certified.

Protection against the impact and compression of the toes. Not suitable for hazards not listed, including chemical, molten metal, live electrical work or chainsaw use.

Suitable for normal ambient working temperatures.

Always ensure the footwear is suitable for hazards and conditions of your workplace.

Fitting: Try on with work socks. Unfasten fully before putting on and taking off. Do not tread down the heel. Seat the heel firmly at the back, then lace evenly from the toe up. Toes should not be touching the toe cap when standing. Fit both feet and choose the size that suits the larger foot.

Care: Brush off loose dirt and wipe with a damp cloth. Do not machine wash, use solvents or dry near a direct heat. Dry naturally at room temperature. Store clean and dry, out of direct sunlight, in a ventilated place. Inspect at least monthly in service.

Warning: Protection applies only when the footwear is complete, correctly fitted and undamaged.

Inspection and replacement: Check before each use, replace if the upper, sole or toe cap is damage or broken.

TECHNICAL FEATURES FOR SAFETY BOOTS
Class I Safety footwear with a leather/textile type upper. The report classifies the footwear as Class I with a non-cleated outsole.
Steel Toe Cap Protective steel toe cap providing protection against mechanical impact and compression.
200 J Impact resistance: toe cap tested at an impact energy of 200 ± 4 J. The footwear passed the required internal height clearance.
15 kN Compression resistance: toe cap tested at a compression force of 15 ± 0.1 kN. The footwear passed the required internal height clearance.
SRA Slip resistance classification. Tested on Euro tile 2 with sodium lauryl sulphate (NaLS) solution. Minimum requirements: 0.28 forward heel slip and 0.32 forward flat slip. The footwear passed SRA.
Non-Cleated Outsole Class I non-cleated outsole. Reported outsole thickness was 14.0–15.0 mm. The applicable Class I non-cleated outsole requirement is minimum 6 mm.
AS 2210.3:2019 Australian Standard used for the safety footwear assessment and identified as the judgement accordance standard.

Levels of Performance: The markings identify the protection and performance characteristics demonstrated by laboratory testing. Performance levels stated above are based on the requirements and results reported for this footwear.

Licensed to Designworks International - 88 Green street Melbourne, Victoria 3121

Email: returns@designwcc.com.au